Recombinant human follicle-stimulating hormone-CTP fusion protein(Suzhou Shengji Pharmaceutical Co Ltd)

The effects of the step-jump approach on the survival and prognosis of infected pancreatic necrosis (IPN) patients have not yet been determined.

Between November 2018 and June 2023, 188 patients were included in this study. There were 144 patients in the step-up group (the SU group) and 44 in the step-jump group (the SJ group). In the SU group, patients successfully treated with percutaneous catheter drainage (PCD) alone were classified into the SU-1 group (n=101), while those requiring additional surgery after PCD were categorized into the SU-2 group (n=43). In the SJ group, patients who underwent minimally invasive necrosectomy (MIN) without PCD were assigned to the SJ-1 group (n=34), whereas those who initially underwent PCD followed by immediate open surgery were placed in the SJ-2 group (n=10). Propensity score matching (PSM) was used to mitigate bias.

After PSM, a total of 34 pairs were successfully matched. A comparison of the SU group with the SJ-1 group (upfront MIN without PCD) revealed similar mortality rates (P=0.239); however, the incidences of multiple drug-resistant organisms (MDROs) (P=0.029) and surgical complications (P<0.001) were significantly lower in the SJ-1 group. After comparing the SU-2 and SJ-2 groups (patients who underwent direct open necrosectomy without MIN after PCD failure), the incidences of surgical complications and MDRO in the SJ-2 group were significantly lower (P<0.05).

Compared with the step-up approach, the step-jump approach is safer and more effective and can significantly reduce the incidence of MDRO and surgical complications.

Ionically-conductive mortar can be used for indoor radiant heating partition walls. In these applications, mortar blocks are soaked in electrolyte solutions of CuSO4. The surfaces of the block are coated with sealant and epoxy resin afterwards to prevent evaporation. The mortar block becomes a heating element due to ionic conduction if a voltage is applied to the electrodes in the block. Its electrical conductivity depends on the dispersion of the electrolyte, and hence on the porosity of the mortar. The test specimens in this study were divided into four groups according to the different air entrainment agents, including aluminum powder and hydrogen peroxide as well as two air-entraining agents, SJ-2 and K12. Each group was manufactured with water/cement ratios in the range of 0.5 to 0.9. The test results showed that the conductivity of the mortar was strongly influenced by the air-entrainment and the water cement ratios. The volumetric electric resistivity and the associated microstructures of the mortar were investigated. The test results showed that the specimens made with aluminum powder and a water–cement ratio of 0.65–0.75 had high porosity. The porosity of those specimens was further increased by adding two different air-entraining agents. The specimens with aluminum powder and SJ-2, along with a water–cement ratio of 0.7 appeared to be the optimum mixture. Its resistivity was 19.37 Ω·m at 28 days under 25.31% porosity. The experimental results indicate that an ionically-conductive mortar can be produced by combining different air-entrainment agents with variable water-cement ratios to meet a specified electrical heating requirement.